Header image with 5 fiddles


Finishing inside, assembly

Remove clamps from carcass. Plane excess material from ribs, stay above blocks level.

Sand to match blocks level.

Trim end blocks to a rounded profile. Sand ribs on inside.

Trim corner blocks for a rounded concave profile and sand.

Fill in any gaps with glue.

Spread glue on both ribs and top plate.

Insert locator pins and clamp.


Use chisels to form scroll to guide lines.

***Note: do NOT go too far!

Check measurements regularly
Leave round centre (eye) to 7 mm
End scroll carving in line with bottom.